Protoilu

Standard issue USB 2.0 cable. Compatible with Arduino Uno, Duemilanove and Mega2560 boards.

A small, but very mighty power supply. This board was designed to be as small and inconspicuous as possible. The nice thing about LiPower is the ability to use rechargable Lithium Polymer batteries. These batteries are smaller, flatter, and last much longer than a AAA battery. Attach a single cell LiPo battery, flip the power switch, and you will have a 5V supply to power your LilyPad network. Good up to 150mA. Short circuit protected.

Conductive thread is a creative way to connect various electronics onto clothing. This thread can carry current for power and signals. While not as conductive as traces on a printed circuit board (PCB), this thread makes wearable clothing 'wearable'!

This breakout board uses the LTC3588 Piezoelectric Energy Harvester from Linear Technologies. This board can be used not only for harvesting piezoelectric energy, but solar energy as well. There is a bridge rectified input for piezo elements (PZ1 and PZ2) and a direct input (VIN) for DC sources. Both are clamped to 20V. In addition, the board can simply be used as a standalone nanopower buck regulator.

Conductive thread is a creative way to connect various electronics onto clothing. This thread can carry current for power and signals. The extra thick thread has an extremely low resistance of about 1.4 Ohms per linear foot and weighs about 0.93 ounces for the full 50 feet.

Naaras-naaras hyppylangasetti.

• Pituus: 150 mm
• Väri: Valkoinen
• 25 kpl paketti

Naaras-naaras hyppylangasetti.

• Pituus: 150 mm
• Väri: Vihreä
• 25 kpl paketti

Polymer Lithium Ion Battery. 6 Ah.

Litium-polymer akku. Kapasiteetti 400 mAh.

A to Mini-B 5 Pin USB cable. Compatible with Arduino Fio, FTDI Basic Breakout etc.

This kit includes 95 pieces of heat shrink, all of varying colors and sizes. All pieces are 10cm in length.

This is a 8-pin female header, with extra long legs that are slightly offset. The offset helps correct for the weird 0.16" spacing between the two 8-pin headers on the digital side of an Arduino. Stick this and an 8-pin Stackable Header on an Arduino and D7 and D8 pins will be spaced by a more standard 0.2". This allows you to then use a standard perf board stacked on top of the Arduino.

A jumper wire kit. 75 wires of varying colors and lengths

These 0.1" spaced header pins simply snap into place and create a good solid electrical connection without soldering.

Thermoelectric coolers (TEC or Peltier) create a temperature differential on each side. One side gets hot and the other side gets cool. Therefore, they can be used to either warm something up or cool something down, depending on which side you use.

Full size breadboard with 830 tie points. White.

Full size breadboard with 830 tie points. Transparent.

Half-size breadboard with 400 tie points.

Half-size breadboard with 400 tie points.