Kaapelit ja hyppylangat

A jumper wire kit. 75 wires of varying colors and lengths

Conductive thread is a creative way to connect various electronics onto clothing. This thread can carry current for power and signals. The extra thick thread has an extremely low resistance of about 1.4 Ohms per linear foot and weighs about 0.93 ounces for the full 50 feet.

Naaras-naaras hyppylangasetti.

• Pituus: 150 mm
• Väri: Valkoinen
• 25 kpl paketti

Naaras-naaras hyppylangasetti.

• Pituus: 150 mm
• Väri: Vihreä
• 25 kpl paketti

This is a simple two wire cable. Great for jumping from board to board. 2-pin JST connector on one end, bare cable on the opposite end.

Standard threaded hook-up wire. Cross-section: 0.22 mm2 (roughly 23 AWG).

Price is for one meter.

Standard threaded hook-up wire. Cross-section: 0.22 mm2 (roughly 23 AWG).

Price is for one meter.

Standard threaded hook-up wire. Cross-section: 0.22 mm2 (roughly 23 AWG).

Price is for one meter.

Standard threaded hook-up wire. Cross-section: 0.22 mm2 (roughly 23 AWG).

Price is for one meter.

Standard threaded hook-up wire. Cross-section: 0.22 mm2 (roughly 23 AWG).

Price is for one meter.

Three pin JST connector with red, black, and yellow colors. 5 inch wire outs. This cable comes fully assembled as shown and connects directly to many different Sharp sensors.

A set of alligator clip cables. 10 pieces in 5 different colors. 2 of each color

A to Mini-B 5 Pin USB cable. Compatible with Arduino Fio, FTDI Basic Breakout etc.

Standard issue USB 2.0 cable. Compatible with Arduino Uno, Duemilanove and Mega2560 boards.