Ostoskorissasi ei ole yhtään tuotetta.

Product was successfully added to your shopping cart.

DIY Audio



18 tuote(tta)

  1. SparkFun I2C DAC Breakout - MCP4725

    The MCP4725 is an I2C controlled Digital-to-Analog converter (DAC). A DAC allows you to send analog signal, such as a sine wave, from a digital source, such as the I2C interface on the Arduino microcontroller.‌

  2. pHAT DAC

    ‌The pHAT DAC provides a super affordable high-quality DAC for the Raspberry Pi. Pumping out 24-bits at 192KHz of audio goodness from the Raspberry Pi's I2S interface on the 2x20 pin GPIO header.

    14,00 €
  3. Dual Phono Connector for pHAT DAC

    Dual phono connector for the pHAT DAC.

  4. NE555P Timer

    555 timer.

  5. 40106 - Inverter Gate, Schmitt Trigger, 6 Gate, 1 Input

    ‌‌CD40106BE consists of six Schmitt-trigger circuits. Each circuit functions as an inverter with Schmitt-trigger action on the input. The trigger switches at different points for positive- and negative-going signals.

  6. 4060 - 14 Stage Binary Counter/divider and Oscillator

    ‌‌The CD4060BE is CMOS 14 stage ripple carry binary counter/divider and oscillator in 16 pin DIP package.

  7. 4017 - Counter/Sequencer Chip

    The 4017 is a handy chip for building DIY sequencers and other counters. Feed in a clock signal from a 555 or some other oscillator to count up the steps. Counts between 1-10. Daisy chain multiple 4017s to count to bigger numbers.

  8. 4093 – Quad 2-Input NAND Schmitt Trigger

    Quad 2-Input NAND Schmitt Trigger

  9. Voice Modulator IC - HT8950

    Want to sound like a robot? The HT8950 is a single chip CMOS LSI voice modulator ICs which provide seven steps to shift the frequency of an input voice, producing a dramatic change in the output.

  10. LM386N – Audio Amplifier

    ‌The classic LM386 amplifier chip.

  11. Op Amp - Dual Rail-to-Rail - 2.7-6V power @ 80mA output - TLV2462

    ‌‌When you need to amplify, filter, add, or otherwise manipulate analog signals you'll certainly want an operational amplifier at your side.

  12. SparkFun Proto Pedal

    ‌The SparkFun Proto Pedal is an easy-to-assemble kit that makes building guitar effect pedals easier.

    29,90 €
  13. Proto Pedal Enclosure

    This is the Proto Pedal Enclosure, a custom-machined aluminum case designed specifically for the SparkFun Proto Pedal.

    25,00 €
  14. Teensy Audio Board

    ‌‌This is the Teensy Audio board add-on for the Teensy 3.0 and 3.1 development boards. This audio board provides you with an easy-to-use tool to add high quality 16 bit, 44.1 kHz sample rate audio to your Teensy project. 

    17,50 €
  15. Teensy LC

    ‌The Teensy LC (Low Cost) is a 32 bit microcontroller board that provides you with an uncomplicated option for getting started with the Teensy line of products without breaking the bank!

    13,50 €
  16. Teensy 3.2

    The Teensy is a breadboard-friendly development board with loads of features in a, well, teensy package.

    20,00 €
  17. Teensy 3.6

    ‌The new Teensy 3.6 board with 180 MHz ARM Cortex-M4

    34,00 €
  18. Teensy 3.5

    ‌The new Teensy 3.5 board with 120MHz ARM Cortex-M4.

    28,00 €


18 tuote(tta)