Rekisteröitymisessä tilauksen yhteydessä on ollut ongelmia. Ongelma on nyt korjattu.

0Item(s)

Ostoskorissasi ei ole yhtään tuotetta.

Product was successfully added to your shopping cart.

LCD

Laskeva

   

8 tuote(tta)

  1. Adafruit 2.8" TFT Touch Shield for Arduino w/ Capacitive Touch

    A capaciteve touchscreen shield for the Arduino.
    46,00 €
  2. Raspberry Pi 7" Touch Screen Display

    ‌7" capacitive touch screen for the Raspberry Pi.

    89,00 €
  3. Liquid Crystal Light Valve - LCD Controllable Black-out Panel

    ‌A Liquid Crystal Light Valve (a.k.a a LCD Controllable Black-out Panel).

  4. Basic 16x2 Character LCD - White on Black 5V

    This is a basic 16 character by 2 line display with a snazzy black background with white characters. Utilizes the extremely common HD44780 parallel interface chipset. Interface code is freely available. You will need ~11 general I/O pins to interface to this LCD screen. Includes white LED backlight.

    14,00 €
  5. Basic 16x2 Character LCD - White on Black 3.3V

    This is a 16 character by 2 line display that runs at 3.3V. Utilizes the common ST7066/HD44780 parallel interface. Interface code is widely available for many different controllers and systems. You will need ~11 general I/O pins to interface to this LCD screen. Includes white LED backlight.

    14,00 €
  6. Basic 16x2 Character LCD - RGB Backlight 5V

    This is similar to other 16x2 character LCDs that you've seen before but with one vibrant difference: The backlight is actually an RGB LED. This means that you can change the backlight of this display to any color you want by controlling the three backlight levels. It also utilizes an extremely common parallel interface so code is freely available (check below for an Arduino example). You will need ~11 general I/O pins to interface to this LCD screen, plus an extra 3 pins for the RGB backlight.

    14,00 €
  7. Serial Enabled 16x2 LCD - White on Black 5V

    This is the latest evolution of Sparkfun's serial LCD. Included on a single board is a 16x2 LCD and an embedded circuit based around a PIC 16F88. The on-board PIC takes a TTL serial input and prints the characters it receives onto the LCD. The installed firmware also allows for a number of special commands so you can clear the screen, adjust the backlight brightness, turn the display on/off, and more.

    24,00 €
  8. RGB LCD Shield Kit w/ 16x2 Character Display - Only 2 pins used! - POSITIVE DISPLAY

    This new Adafruit shield makes it easy to use a 16x2 Character LCD. It allows you to control a 16x2 Character LCD, up to 3 backlight pins AND 5 keypad pins using only the two I2C pins on the Arduino! The best part is you don't really lose those two pins either, since you can stick i2c-based sensors, RTCs, etc and have them share the I2C bus. This is a super slick way to add a display without all the wiring hassle.

    Please note that this is a kit that requires assembly.

    24,00 €
Laskeva

   

8 tuote(tta)