Rekisteröitymisessä tilauksen yhteydessä on ollut ongelmia. Ongelma on nyt korjattu.

0Item(s)

Ostoskorissasi ei ole yhtään tuotetta.

Product was successfully added to your shopping cart.

Kaapelit ja hyppylangat

Laskeva

   

Tuotteet 1-20 / 28

  1. 1
  2. 2
  1. Silicone Cover Stranded-Core Wire - 15m 30AWG Blue

    ‌Silicone covered wire. It's soft and flexible.

  2. Silicone Cover Stranded-Core Wire - 15m 30AWG Red

    ‌Silicone covered wire. It's soft and flexible.

    6,00 €
  3. Jumper Wire Kit (65 Pieces)

    A jumper wire kit. 65 wires of varying colors and lengths

  4. Premium Male/Male Jumper Wires - 40 x 3" (75mm)

    40 pieces of 75 mm jumper cables.
  5. Premium Male/Male Jumper Wires - 40 x 6" (150mm)

    40 pieces of 150 mm jumper cables.

  6. Premium Female/Female Jumper Wires - 40 x 3" (75mm)

    ‌Female to female jumper wires. 75 mm long.

  7. Premium Female/Female Jumper Wires - 40 x 6" (150m)

    ‌Female to female jumper wires. 150mm long

  8. Alligator Test Leads - Multicolored (10 Pack)

    A set of alligator clip cables. 10 pieces in 5 different colors. 2 of each color

  9. Infrared Sensor Jumper Wire - 3-Pin JST

    Three pin JST connector with red, black, and yellow colors. 5 inch wire outs. This cable comes fully assembled as shown and connects directly to many different Sharp sensors.

  10. Wire With JST Connector – Black Red

    This is a simple two wire cable. Great for jumping from board to board. 2-pin JST connector on one end, bare cable on the opposite end.

  11. Ribbon Cable - 6 wire (4.5m/15ft)

    Ribbon cable is really helpful in situations where you need to make a lot of connections without a big mess of wires. Nothing makes a project look more finished than a nice clean wiring harness.

    3,00 €
  12. Ribbon Cable - 10 wire (4.5m/15ft)

    Ribbon cable is really helpful in situations where you need to make a lot of connections without a big mess of wires. Nothing makes a project look more finished than a nice clean wiring harness.

  13. USB microB Cable - 1.8 m

    USB 2.0 type A to micro USB 5-pin. This is a new, smaller connector for USB devices. Micro USB connectors are about half the height of mini USB. Micro USB is found on newer hand held devices like cell phones and portable media devices.

    For Arduino Leonardo, Raspberry Pi or any other of our products with microUSB.

  14. USB 'Noodle' Cable - A/MicroB - 1 meter

    ‌1 meter long flat microUSB cable

  15. USB Cable A to Mini-B – 1.8 Meters

    A to Mini-B 5 Pin USB cable. Compatible with Arduino Fio, FTDI Basic Breakout etc.

  16. USB Cable A to B – 1.8 Meters

    Standard issue USB 2.0 cable. Compatible with Arduino Uno, Duemilanove and Mega2560 boards.

  17. Panel Mount USB Cable - A Male to A Female

    ‌‌This handy USB extension cable will make it easy for you to enclose a device that has a A type (USB host) port. We think this would be most handy when putting a Beagle Bone, Raspberry Pi or Mintyboost into a box.

  18. Panel Mount Ethernet Extension Cable

    ‌‌This handy Ethernet extension cable will make it easy for you to enclose a device that has an Ethernet port. We think this would be most useful when putting a Beagle Bone, Raspberry Pi, Arduino Ethernet into a box.

  19. Panel mount HDMI Cable - 40 cm

    ‌‌This panel mount extension cable will allow you to extend an HDMI connection and secure it to an enclosure. Perfect for placing your Raspberry Pi in a secure box. 

  20. 12.0" JST Male to Male Extension

    ‌‌Use this connector cable with the our gear motors and the connector boards.

Laskeva

   

Tuotteet 1-20 / 28

  1. 1
  2. 2