Ostoskorissasi ei ole yhtään tuotetta.

Product was successfully added to your shopping cart.




14 tuote(tta)

  1. SparkFun RGB and Gesture Sensor - APDS-9960

    ‌This is the SparkFun RGB and Gesture Sensor, a small breakout board with a built in APDS-9960 sensor that offers ambient light and color measuring, proximity detection, and touchless gesture sensing
    15,00 €
  2. Pololu Carrier with Sharp GP2Y0A60SZLF Analog Distance Sensor 10-150cm, 5V

    ‌The GP2Y0A60SZ distance sensor from Sharp offers a wide detection range of 4″ to 60″ (10 cm to 150 cm) and a high update rate of 60 Hz. The distance is indicated by an analog voltage, so only a single analog input is required to interface with the module. The sensor ships installed on our compact carrier board, which makes it easy to integrate this great sensor into your project, and is configured for 5V mode.

    13,50 €
  3. Adafruit 12-Key Capacitive Touch Sensor Breakout - MPR121

    ‌‌Add lots of touch sensors to your next microcontroller project with this easy-to-use 12-channel capacitive touch sensor breakout board, starring the MPR121. This chip can handle up to 12 individual touch pads.

  4. ZX Distance and Gesture Sensor

    ‌‌The ZX Distance and Gesture Sensor is a touchless sensor that is capable of looking for simple gestures.

    28,00 €
  5. Ultrasonic Sensor - HC-SR04

    An ultrasonic sensor that provides 2cm to 400cm of non-contact measurement functionality with a ranging accuracy that can reach up to 3mm.

  6. SparkFun Grid-EYE Infrared Array Breakout - AMG8833 (Qwiic)

    ‌The SparkFun Grid-EYE Infrared Array Breakout board is an 8x8 thermopile array, meaning you have a square array of 64 pixels capable of independent temperature detection. It’s like having a thermal camera, just in a lower resolution.

    39,95 €
  7. Omron D6T-44L – MEMS Thermal Sensor

    The D6T-44L is a great little sensor for detecting temperature of a 4X4 grid area. Can be used to detect temperature changes in the environment or as a body heat sensor for detecting humans. Basically, it is a very low resolution (4x4 pixels) thermal camera with an I2C interface that works great with microcontrollers such as the Arduino.

    65,00 €
  8. Infrared Proximity Sensor Short Range - Sharp GP2D120XJ00F

    Infrared proximity sensor. 3 cm to 30 cm range.

    15,00 €
  9. Ultrasonic Range Finder - Maxbotix HRLV-EZ1

    These easy-to-use ultrasonic rangefinders from Maxbotix work the same way as the EZ line that you know and love, but this new high-resolution series features 1 millimeter resolution! As with the rest of the Maxbotix range finders, these sensors feature Analog Voltage, RS232 Serial, and Pulse Width outputs making them easy to interface with any microcontroller. These sensors have a maximum range of 5000 mm (195 inches) with virtually no dead zone (although objects closer than 30 cm will typically range as 30 cm).

    35,00 €
  10. Ultrasonic Range Finder – Maxbotix LV-EZ1

    Easy to use ultrasonic sensor from Maxbotics.

    27,00 €
  11. Infrared Proximity Sensor Long Range - Sharp GP2Y0A02YK0F

    Infrared proximity sensor. 15 cm to150 cm range.

    15,00 €
  12. Infrared Sensor Jumper Wire - 3-Pin JST

    Three pin JST connector with red, black, and yellow colors. 5 inch wire outs. This cable comes fully assembled as shown and connects directly to many different Sharp sensors.

  13. PIR Motion Sensor

    PIR Motion Sensor

    11,00 €
  14. MPR121 Capacitive Touch Sensor Breakout Board

    This is a breakout board for Freescale's MPR121QR2. The MPR121 is a capacitive touch sensor controller driven by an I2C interface. The chip can control up to twelve individual electrodes, as well as a simulated thirteenth electrode. The MPR121 also features eight LED driving pins. When these pins are not configured as electrodes, they may be used to drive LEDs.

    9,00 €


14 tuote(tta)